Slant Six Forum
https://slantsix.org/forum/

CC'ing the chamber
https://slantsix.org/forum/viewtopic.php?t=63416
Page 1 of 1

Author:  GregCon [ Thu Mar 21, 2019 1:15 pm ]
Post subject:  CC'ing the chamber

Just as an 'informational' shot, I cc'd a chamber on my 225 head. You can tell by the dusty stand how often I do this, lol. The chamber came out at 47.5 cc's. This is after a .070" cut off of a stock head. The valves and exh seats are new, so that helps reduce the cc's a bit over old ones that might have been ground.

I haven't cc'd the piston yet, but if it's .160" down, I'll have a CR right at 9:1 which is right at what I wanted.

Attachments:
cc chamber 47.5.JPG
cc chamber 47.5.JPG [ 107.12 KiB | Viewed 2742 times ]

Author:  upnover [ Thu Mar 21, 2019 5:03 pm ]
Post subject:  Re: CC'ing the chamber

good info, fixing to have a head cut too.

Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/