Slant Six Forum
https://slantsix.org/forum/

Old bulletin float
https://slantsix.org/forum/viewtopic.php?t=63479		 Page 1 of 1
Author:  matv91 [ Sat Apr 06, 2019 12:02 pm ]
Post subject:  Old bulletin float
Image
Author:  matv91 [ Sat Apr 06, 2019 12:05 pm ]
Post subject:  Re: Old bulletin float
Image
Author:  matv91 [ Sat Apr 06, 2019 12:08 pm ]
Post subject:  Re: Old bulletin float
Image
Author:  matv91 [ Mon Feb 17, 2020 9:33 pm ]
Post subject:  Re: Old bulletin float
This was not just a one time bulletin,these instructions were in the 1977 service manual and every year after that to at least 1983,newest i have to check.
Author:  Jase [ Wed Sep 29, 2021 10:36 am ]
Post subject:  Re: Old bulletin float
Quote:
Image
This is a wonderful contribution. I would never have dared to do this on vehicle, but I can follow directions and get the work done with half the stress.

Thanks Matv91
Author:  SlantSixDan [ Wed Sep 29, 2021 1:01 pm ]
Post subject:  Re: Old bulletin float
Also works for Carter BBS. Remove two front/short airhorn-main body screws, remove one long airhorn-main body-throttle body screw and replace with short screw to hold main body to throttle body; repeat with another long screw on the other side of the carb. Remove (applicable linkages and) other two long screws. Proceed with float adjustment.
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/