| Slant Six Forum https://slantsix.org/forum/ |
|
| Swap pushbotton trans for 1971 A904, what trans mount do I need? https://slantsix.org/forum/viewtopic.php?t=63729 |
Page 1 of 1 |
| Author: | drgonzo [ Fri Jun 14, 2019 6:27 am ] |
| Post subject: | Swap pushbotton trans for 1971 A904, what trans mount do I need? |
This swap is in a 1963 Dart. Do I need to pick up a different rear trans mount than the one for the '63 push button trans? Thanks guys. |
|
| Author: | Dart270 [ Fri Jun 14, 2019 6:31 am ] |
| Post subject: | Re: Swap pushbotton trans for 1971 A904, what trans mount do I need? |
If the mount is still in your stock X-member, I am pretty sure you do not need to change anything. The mount only changes for the different year car's X-member, the A-body 904s (maybe all?) have the mount in the same place throughout the years. Lou |
|
| Author: | Charrlie_S [ Fri Jun 14, 2019 6:38 am ] |
| Post subject: | Re: Swap pushbotton trans for 1971 A904, what trans mount do I need? |
If you are not using a 68 up engine/crank, this swap will not work, without a special converter. But the mount is the same. |
|
| Author: | drgonzo [ Fri Jun 14, 2019 7:02 am ] |
| Post subject: | Re: Swap pushbotton trans for 1971 A904, what trans mount do I need? |
I am swapping engines as well. Thanks. |
|
| Author: | GTS225 [ Fri Jun 14, 2019 10:08 am ] |
| Post subject: | Re: Swap pushbotton trans for 1971 A904, what trans mount do I need? |
Isn't there a problem when going from a cable shifter to a linkage trans? Roger |
|
| Author: | drgonzo [ Fri Jun 14, 2019 10:58 am ] |
| Post subject: | Re: Swap pushbotton trans for 1971 A904, what trans mount do I need? |
I am using an aftermarket shifter. |
|
| Author: | Charrlie_S [ Fri Jun 14, 2019 4:09 pm ] |
| Post subject: | Re: Swap pushbotton trans for 1971 A904, what trans mount do I need? |
Then everything should be a "bolt in", except for driveshaft. There are some driveshafts that will swap right in, but i'm not sure which year/model can be used. Also rear end used will affect which driveshaft is required. PS: speedo cable will need to be changed to one for a 66 "A" body. |
|
| Author: | drgonzo [ Fri Jun 14, 2019 7:51 pm ] |
| Post subject: | Re: Swap pushbotton trans for 1971 A904, what trans mount do I need? |
I will have to have a driveshaft fabbed up or at least modified since I am using a 9" Ford rear end. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|