Slant Six Forum
https://slantsix.org/forum/

Aussie Speed Contact ? Header Info Needed
https://slantsix.org/forum/viewtopic.php?t=63774		 Page 1 of 1
Author:  hyper_pak [ Sun Jun 30, 2019 2:17 pm ]
Post subject:  Aussie Speed Contact ? Header Info Needed
I should know this, but do we know who is the US Rep for the products? I have a question about the headers.
Anyone purchased a set of the race headers? Like this image. I am thinking for the Colt and the tube chassis this might be the way to go.
I built the head pipes for the Hyper Pak manifolds and while it was rewarding, it was time consuming and not cheap.
And any thoughts on the current practice of dumping out the lower fender?
Thanks Slanters...

Attachments:
Aussiespeed Headers.JPG
Aussiespeed Headers.JPG [ 34.58 KiB | Viewed 4027 times ]
A Header T Pipe.JPG
A Header T Pipe.JPG [ 69.41 KiB | Viewed 4027 times ]
Author:  Doctor Dodge [ Sun Jun 30, 2019 9:21 pm ]
Post subject:  Re: Aussie Speed Contact ? Header Info Needed
Corey at Small Town Speed may be able to help...
972-989-4003
Author:  Dave M [ Mon Jul 01, 2019 8:01 am ]
Post subject:  Re: Aussie Speed Contact ? Header Info Needed
I have one set of the race headers on my 69 Valiant and they fit pretty good. They do point towards the ground and can make some big clouds of dust when you are not moving. My main track I race at, with that car at is Woodburn and it's all black top and grass. You could weld on some extensions and keep the exhaust parallel with the ground like a normal V8 header.
Author:  hyper_pak [ Mon Jul 01, 2019 11:48 am ]
Post subject:  Re: Aussie Speed Contact ? Header Info Needed
Thanks for the info. How are the head flanges, problems with sealing? I like the Clifford thick flange, the Hookers I had with the thin flange and mickey mouse spacers were a real pain. I really don't want to blow a bunch of stuff when I start it and run it around the pits. Thinking something like this:

Attachments:
A Header Exhaust.JPG
A Header Exhaust.JPG [ 12.96 KiB | Viewed 3949 times ]
Author:  Dave M [ Tue Jul 02, 2019 7:27 am ]
Post subject:  Re: Aussie Speed Contact ? Header Info Needed
The flanges on the Aussie headers are only about 3/8 compared to the "normal" 1/2 thick flanges. Did have to mess with the tabs a little but had no exhaust leaks. This help ?
Author:  hyper_pak [ Tue Jul 02, 2019 5:28 pm ]
Post subject:  Re: Aussie Speed Contact ? Header Info Needed
Yes, thanks. I just want a simple fool proof system, don't need any leaks or a lot of trouble installing and removing them. I really think the Clifford flange is the best. I have a set of shortys, but they look like they leave a lot on the table for performance.
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/