https://www.instagram.com/p/Bz0pzQ6FcD0/
| Slant Six Forum https://slantsix.org/forum/ |
|
| Recent Mopar Collectors Guide IG photo https://slantsix.org/forum/viewtopic.php?t=63819 |
Page 1 of 1 |
| Author: | Buick [ Fri Jul 12, 2019 11:24 pm ] |
| Post subject: | Recent Mopar Collectors Guide IG photo |
https://www.instagram.com/p/Bz0pzQ6FcD0/
|
|
| Author: | Dart270 [ Sat Jul 13, 2019 3:55 am ] |
| Post subject: | Re: Recent Mopar Collectors Guide IG photo |
Nice looking car/engine. Thanks for posting the link. Anyone recognize it?? Lou |
|
| Author: | Rick Covalt [ Sat Jul 13, 2019 4:06 am ] |
| Post subject: | Re: Recent Mopar Collectors Guide IG photo |
Yes that is Larry Bird from Hagerstown ,Md. He was at the banquet this year with us. It is in a 66 Valiant. He hopes to race with us in the Fall or next season for sure. |
|
| Author: | emsvitil [ Sat Jul 13, 2019 4:57 am ] |
| Post subject: | Re: Recent Mopar Collectors Guide IG photo |
How does that turbo work? I can't quite figure out the plumbing.... |
|
| Author: | Dart270 [ Sat Jul 13, 2019 10:31 am ] |
| Post subject: | Re: Recent Mopar Collectors Guide IG photo |
Of course! I knew the car looked familiar. I saw it at M-D in May... Lou |
|
| Author: | slantzilla [ Sat Jul 13, 2019 11:15 am ] |
| Post subject: | Re: Recent Mopar Collectors Guide IG photo |
Looks like it's plumber through an intercooler. |
|
| Author: | Rick Covalt [ Sat Jul 13, 2019 12:34 pm ] |
| Post subject: | Re: Recent Mopar Collectors Guide IG photo |
Yes has a big intercooler down low out front |
|
| Author: | emsvitil [ Sat Jul 13, 2019 4:08 pm ] |
| Post subject: | Re: Recent Mopar Collectors Guide IG photo |
I figured out the intercooler...……. Looks like the exhaust section is in front and heat wrapped. To me it looks like the input to the compressor goes forward to the intercooler. (after making a 180 to the fender) Where's the output of the compressor? |
|
| Author: | sixinthehead [ Sat Jul 13, 2019 4:38 pm ] |
| Post subject: | Re: Recent Mopar Collectors Guide IG photo |
The compressor outlet points straight at the inner fender, going through right in front of the upper A-arm where I assume it turns forward/down to reach the driver's side of the intercooler. You can just make it out past the inner fender ridge. I really like that turbo header  Who's gonna start selling those   
|
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|