| Slant Six Forum https://slantsix.org/forum/ |
|
| main bearings https://slantsix.org/forum/viewtopic.php?t=6528 |
Page 1 of 1 |
| Author: | heckshemi [ Mon Aug 11, 2003 11:48 pm ] |
| Post subject: | main bearings |
I'm rebuilding my 170 for high performance naturally aspirated use and I expect it to see some fairly high revs. I think I read somewhere that you should use the grooved main bearing in both halves to increase oiling to the rods. Is this sound advice? I want the bottom end to live. Thanks, Frank |
|
| Author: | Charrlie_S [ Tue Aug 12, 2003 5:28 am ] |
| Post subject: | |
I use full grooved mains in my engines. Check out the articules section, for oil system mods. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|