Slant Six Forum
https://slantsix.org/forum/

A crank trigger to go with the cam sensor
https://slantsix.org/forum/viewtopic.php?t=65977		 Page 1 of 1
Author:  MadScientistMatt [ Tue May 18, 2021 11:18 am ]
Post subject:  A crank trigger to go with the cam sensor
The crank trigger is a prototype that was intended for a small block Chevy. I'm going to use a threaded Hall effect sensor here and a bit of square tubing welded to the timing cover. Some work in progress pictures:

Image

Image

Image

My welding skills aren't the greatest, but at least I don't have any more holes in the timing cover than I started with.
Author:  Dart270 [ Tue May 18, 2021 12:38 pm ]
Post subject:  Re: A crank trigger to go with the cam sensor
Hi Matt,

Looks very similar to what I did on mine. See pics at: https://flickr.com/photos/16910097@N06/ ... 2740650932

I used your cam sensor (fuel pump plate) idea and it is perfect! Thanks again.

Lou
Author:  MadScientistMatt [ Wed May 19, 2021 10:31 am ]
Post subject:  Re: A crank trigger to go with the cam sensor
Looks like you were a bit more confident in your welding skills getting the gap right than I am! I went with a threaded Hall effect sensor. Everything ready now except paint and finishing the wiring.

Image

Image

Image

Image

Image
Author:  emsvitil [ Wed May 19, 2021 7:18 pm ]
Post subject:  Re: A crank trigger to go with the cam sensor
Is that a 36-1 wheel?
Author:  MadScientistMatt [ Thu May 20, 2021 6:52 am ]
Post subject:  Re: A crank trigger to go with the cam sensor
Quote:
Is that a 36-1 wheel?
Correct.
Author:  Greg Ondayko [ Fri May 21, 2021 11:44 am ]
Post subject:  Re: A crank trigger to go with the cam sensor
Quote:
Is that a 36-1 wheel?

Yes but it's a prototype SB chevy one that bolts nicely to the Romac for a slant 6 - would like matt/ Diyautotune to make some more of them... wink wink, nudge, nudge.

Greg
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/