| Slant Six Forum https://slantsix.org/forum/ |
|
| Distributor O-ring: one or two? https://slantsix.org/forum/viewtopic.php?t=66969 |
Page 1 of 1 |
| Author: | valleyguy [ Mon Dec 19, 2022 7:04 am ] |
| Post subject: | Distributor O-ring: one or two? |
When I removed my distributor (63 valiant, slant six), I only found one O-ring, the large one that fits in the block recess. I read somewhere that there are supposed t be two O-rings. True? If so, where does the second one go? |
|
| Author: | SlantSixDan [ Mon Dec 19, 2022 9:19 am ] |
| Post subject: | Re: Distributor O-ring: one or two? |
Two; see here |
|
| Author: | valleyguy [ Mon Dec 19, 2022 12:51 pm ] |
| Post subject: | Re: Distributor O-ring: one or two? |
Where does that second o-ring go? I do see a smaller one already in place on the dist shaft. Is that the one? |
|
| Author: | SlantSixDan [ Mon Dec 19, 2022 1:21 pm ] |
| Post subject: | Re: Distributor O-ring: one or two? |
Locations are described in linked post: small/lower in distributor shank groove; large/upper just under hold-down plate. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|