I do not have access to a proper "Connecting rod heater";
can I use a Mapp / Propane Torch to heat the small end to drop the pin through?

I can also freeze the Piston pins to hopefully make them a few 0.0001"ths smaller.


Thank you sages,

Greg

_________________
http://www.youtube.com/hyperpack

Your torch setup will be fine and heat the rods to expand them effortlessly. No need to freeze the pins. You'll just need to make a pin stop so they will be centered once you install them....

_________________
There's no such thing as too much cam....only not enough engine!

Sounds good thanks,

I just do not want to somehow damage the rods from overheating.

_________________
http://www.youtube.com/hyperpack