Yep, Nick! Sure good to hear from you! I was going to say I would be interested in a 198 crank, but I'm not sure why!
So glad Greg and Lou are getting them! Take care.
| Slant Six Forum https://slantsix.org/forum/ |
|
| Slant parts clean out https://slantsix.org/forum/viewtopic.php?t=68440 |
Page 1 of 1 |
| Author: | turboram [ Tue Nov 25, 2025 5:59 pm ] |
| Post subject: | Slant parts clean out |
Edit! I am out of room . Here is what I have I have a couple tall deck blocks Several heads. 2 727 1 old rear pump 904 I have quite a few misc engine parts. All parts above are cheap. Make offer, however I dont want to however I dont want tons of hassle. Thanks guys!! |
|
| Author: | Dart270 [ Wed Nov 26, 2025 1:09 am ] |
| Post subject: | Re: Slant parts clean out |
Nice to e-see you again, Nick. PM sent. Lou |
|
| Author: | Greg Ondayko [ Wed Nov 26, 2025 5:11 am ] |
| Post subject: | Re: Slant parts clean out |
I will take whatever loose 198 Parts (rods and Cranks) that Lou did not buy. PM coming. Greg |
|
| Author: | Rick Covalt [ Wed Nov 26, 2025 4:30 pm ] |
| Post subject: | Re: Slant parts clean out |
Yep, Nick! Sure good to hear from you! I was going to say I would be interested in a 198 crank, but I'm not sure why! So glad Greg and Lou are getting them! Take care.
|
|
| Author: | Greg Ondayko [ Wed Dec 24, 2025 6:06 pm ] |
| Post subject: | Re: Slant parts clean out |
Quote:
I was going to say I would be interested in a 198 crank, but I'm not sure why!
Here's Why 198 Cranks are fun.. Not for RG Blocks but in G blocks - turns a 170 into a ~210CI Screaming' Monster... With a little block clearancing etc. So glad Greg and Lou are getting them!
I have acquired 4 170's over the last 3 years and I almost wanted to buy the Slant Guy From Kentucky (whose name I cannot remember now)/Ryan Covalt's/ David Shank's 170 ci. 4 Door, 833 OD, '65? Valiant, finished in Grey |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|