| Slant Six Forum https://slantsix.org/forum/ |
|
| Ignition / headlight / wiper switch bezel tool https://slantsix.org/forum/viewtopic.php?t=68551 |
Page 1 of 1 |
| Author: | MadScientistMatt [ Mon Feb 23, 2026 4:58 pm ] |
| Post subject: | Ignition / headlight / wiper switch bezel tool |
I CAD'd up a tool to remove and install the ignition switch bezel on my '66 Dart - I have been working on the dash way too much lately. It should fit most early to mid 1960s Chrysler projects. I printed it from PLA and the result was a bit flimsy; if you want to try printing one, use a strong plastic and make sure you have good layer adhesion. I'll see if ordering some made from commercially printed nylon do better. I've posted an STL anyone can download and print for non-commercial purposes here: https://cramerpower.com/products/dash-b ... -file-only |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|