Slant Six Forum
https://slantsix.org/forum/

Some parts I probably will never use
https://slantsix.org/forum/viewtopic.php?t=68738		 Page 1 of 1
Author:  volaredon [ Wed Aug 26, 2026 6:39 pm ]
Post subject:  Some parts I probably will never use
I have (3) only.. new in box MP 4529418 0.060 over /6 pistons.
Think I can remember what I paid a few years ago, but don't know what they're "worth".

And then I have an old 8-3/4. . I tried sending a couple of pix to another member by PM and it didn't work (?) so I'll try again here. I know it's a '57-64, splined ends for the drums, prior research as I remember said it's basically the same as a "742". 4.10 open, and I can't say for certain other than that the yoke has never had a u joint connected to it, I'm thinking the innards are very fresh.
The value would be the chunk and not the housing, I only left it intact to keep it clean and sealed.
The housing has been modified to fit I don't know what.
Let's try pix again

Attachments:
IMG_20230401_155710404.jpg
IMG_20230401_155710404.jpg [ 669.59 KiB | Viewed 12 times ]
IMG_20230401_155805099_HDR.jpg
IMG_20230401_155805099_HDR.jpg [ 1.34 MiB | Viewed 12 times ]
Author:  volaredon [ Wed Aug 26, 2026 6:53 pm ]
Post subject:  Re: Some parts I probably will never use
Let's try a couple more.
Not sure what it's out of, admittedly the value of any would be in the chunk and not the housing.
Which I could pull and probably scrap the housing.
I have no idea what this housing was modified to fit into. I do have a couple of other pix with a tape measure for length etc.

Price? Best offer, just be honest and fair.
Not gonna ship the pistons or the rear end. Could meet up within reason.
Sorry I don't have the vacation time available for our site wide get together that's coming up.
I would like to move these and "trade" for some cash to put towards my truck projects.
I have an 85 d150 with the/6 and an 83 D250, this one is down to the bare frame... Building back up Johnny cash style...
Body in paint jail, redone frame sitting on my lift, engine sitting in machine shop jail.
Have Dana 60 to pick up from sandblaster guy, etc... have cam that needs to go to Oregon cams, that sort of thing.. you guys definitely know how these things go better than anybody...
So like I asked for... Honest and fair offers. Honestly don't have any solid numbers in mind.

Attachments:
IMG_20230401_155742772.jpg
IMG_20230401_155742772.jpg [ 803.59 KiB | Viewed 10 times ]
IMG_20230401_155731619_HDR.jpg
IMG_20230401_155731619_HDR.jpg [ 3.48 MiB | Viewed 10 times ]
IMG_20230401_155722495_HDR.jpg
IMG_20230401_155722495_HDR.jpg [ 3.49 MiB | Viewed 10 times ]
Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/