| Slant Six Forum https://slantsix.org/forum/ |
|
| Brakes(and I) need help! https://slantsix.org/forum/viewtopic.php?t=7211 |
Page 1 of 1 |
| Author: | JohnnyDees [ Mon Oct 13, 2003 5:46 pm ] |
| Post subject: | Brakes(and I) need help! |
I converted my 66 Dart to 74 Duster discs. Its been a while since I took the breaks off the Duster and I want to make sure Im putting the metal clips back on top of the caliper correctly. Also with the caliper came 2 bands and two washers. I assume the washers are for the rubber line but what are the bands for? Thanks in advance ( I dont have a complete setup  to look at)
|
|
| Author: | ducduc [ Wed Oct 15, 2003 2:01 pm ] |
| Post subject: | |
You're talking about the slider type calipers, right? The open end of the clip goes toward the caliper. Those copper washers, they're new? Just pennies for new ones. The bands, I don't know. What kind of bands? |
|
| Author: | JohnnyDees [ Wed Oct 15, 2003 2:44 pm ] |
| Post subject: | |
black rubber bands 2 for each caliper. |
|
| Author: | Craig [ Wed Oct 15, 2003 9:20 pm ] |
| Post subject: | Mysterious disk brake Rubber bands |
Those rubber bands are some sort of anti-rattle thing. The picture in my factory service manuals shows the rubber bands in the breakdown, but no where does it say or show where or how to install them. Does anyone out there know? |
|
| Author: | Pierre [ Wed Oct 15, 2003 10:49 pm ] |
| Post subject: | |
How big are these rubber bands? Could you be referring to chatter springs that fit around the rotor/drum or are they too small for that? |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|