All right!
Nothing to be afraid of...
Congratulations.Now on to more complex issues
| Slant Six Forum https://slantsix.org/forum/ |
|
| I did it! https://slantsix.org/forum/viewtopic.php?t=7543 |
Page 1 of 1 |
| Author: | pantseatflyer [ Thu Nov 13, 2003 8:09 pm ] |
| Post subject: | I did it! |
First time to rebuild a carburetor. I was scared going in, but thanks to your words of encouragement and advice, it turned out not to be as difficult as I had imagined. I layed everything out as I disassembled it, paid close attention to the diagram and followed the adjustment procedures. About an hour ago I bolted it back on and hook up the hoses. A couple of key turns later, it fired right up and my engine sounds better than ever. No more rough idling! Thanks a million! |
|
| Author: | Bruce Johnson [ Thu Nov 13, 2003 8:26 pm ] |
| Post subject: | |
Right On! |
|
| Author: | Seis Inclinado [ Thu Nov 13, 2003 8:32 pm ] |
| Post subject: | You did it! |
All right! Nothing to be afraid of... Congratulations.Now on to more complex issues |
|
| Author: | Doctor Dodge [ Thu Nov 13, 2003 10:44 pm ] |
| Post subject: | |
Well done, we knew you could do it. So.... what is the next project.  DD |
|
| Author: | Middy [ Mon Nov 17, 2003 10:48 am ] |
| Post subject: | |
Boy that's great to hear! It really brings home what the board is all about, even though a lot of electrons are devoted to high HP this is where the board shines. 
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|