Slant Six Forum
https://slantsix.org/forum/

update on intake and exhaust
https://slantsix.org/forum/viewtopic.php?t=8466
Page 1 of 1

Author:  Guest [ Wed Feb 18, 2004 6:16 pm ]
Post subject:  update on intake and exhaust

Got everything dialed in, intake, exhaust, and tranny.

I got the throttle hooked up via cable to a new pedal I bolted to the floor pan (temporary so to speak). The tranny kickdown is wired about halfway and it shifts real well.
Goes 1st-2nd around 15-20mph, and 2nd-3rd anywhere from 45-55mph ( seems high, but I can deal for now).

I had some problems with the chokes so I took them off, and the linkage was not setup properly (my fault from messing with it too much) and one carb was pulling the other one open and I was constantly accelerating with my foot OFF the gas, cruise control from hell.

Got it home and set everything up and it is running cherry. Have the dual dutras running into a single pipe (2.5 inch) out a 2-chamber flowmaster. Sounds good, nice and healthy, but not too loud.

I will get some pictures up in a bit.

Caesar

ps.
Who can host pictures for me so I may post them on the forum? anyone know?

Author:  oibrownskin [ Wed Feb 18, 2004 6:17 pm ]
Post subject: 

i made the original post, just forgot to log in, so just putting me here so i can get PM's and emails.

Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/