| Slant Six Forum https://slantsix.org/forum/ |
|
| Bell Housing fork boot https://slantsix.org/forum/viewtopic.php?t=9950 |
Page 1 of 1 |
| Author: | sixty4dartgt [ Tue Jul 27, 2004 5:31 pm ] |
| Post subject: | Bell Housing fork boot |
I need a new throw out bearing fork boot for my 1964 non-OD 4 speed bell housing. I think the 3 speed is the same. Anyone know where to buy one of these? Also, do I have to install it before I put the bell housing back in, or can I get it in there afterward.  Thanks! 
|
|
| Author: | DusterIdiot [ Tue Jul 27, 2004 5:45 pm ] |
| Post subject: | Should be the same... |
all the one's I've seen are the same whether A-903, A-230, A-833 OD or not... you install the boot after you put the fork on the throwout bearing, but before you install the linkage... -D.Idiot |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|