I have seen a post about offset grinding of the head but cannot find it doing a search so may be asking questions already asked.I have the head off the motor getting oversize valves put in and I was wanting to know the benifits of offset surfacing the head/how much to offset and which side to offset.Is there any reliability issues with this modification etc

When you search try using the term "angle milling",that should get you what you want.
HyperValiant

_________________
1960 Hyper-Pac Valiant(rolling test-bed)
1963 Valiant V2OO(Son's summer project,- he just turned 15 )
1972 Valiant 4dr(Daughter Kelly's repair in progress)
1974 Valiant (v8) daughter Kelly's work in progress

Thanks HyperValiant, I found the links


Old-vc