Clifford short/street rod header fitment

Unanswered topics | Active topics

Home » Board index » Tech Q & A » Engine

All times are UTC-08:00

Clifford short/street rod header fitment

Post new topic Reply to topic

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

Bren67Cuda904

Post subject: Clifford short/street rod header fitment

PostPosted: Wed Feb 06, 2008 6:36 pm

Offline

Board Sponsor

Joined: Tue Jun 27, 2006 8:21 am
Posts: 1614
Location: Orlando, FL
Car Model:

Quote:

Will I also need to relocate my trans lines with the shortly hearders?

http://tinyurl.com/2m6ryh

_________________
67Cuda,FAST EZEFI,340cu,CR=10.25,RollerCam&Rocker (XR268HR,#20-810-9)(#1622-16)(EddyRPM#60779,#7576), (MSD6AL,#6425) A904, GearVendorsOD, 8 1/4,3.55:1, ClassicAir

Top

Profile

Reply with quote

1974duster kev

Post subject:

PostPosted: Thu Feb 07, 2008 8:26 am

Offline

Turbo Slant 6

Joined: Fri Jul 13, 2007 11:11 pm
Posts: 794
Location: clearwater florida
Car Model:

The tranny lines will touch the bottom of your headers (on my 74 duster they did) i just bought some length of braided hose and ran 2 new lines under them down by the motor mount problem solved also i have a bad motor mount so my header is touching my power steering at the moment but if yours are new the motor should sit high enough to clear. Other than that i love my clifford headers. pm if ya need about something.
Thanks, kev

_________________