Heres a couple of good launches

_________________
Nick
86 d150 turbo /6.
64 valiant 4 door

Looks good man!! how many #'s of boost are you giving it? Also, any head work done to it? Later.
Ryan

_________________
10.74 @ 127.47 mph 1320 ft
6.65 @ 107.80 mph 660 ft

http://www.youtube.com/c/turbo66valiant
Follow on Instagram - turbo66valiant
Facebook - https://www.facebook.com/ryan.peterson.737

no head work yet....its holding about 20psi under nos I've had it as high as 24 but never at the track

_________________
Nick
86 d150 turbo /6.
64 valiant 4 door

Well its dead.... or at least the head gasket too it to the track last night and because they had no et racing (no times on the board) and it turns out a 125 shot and 20psi of boost full track will kill a gasket, the runs before was a 12.0 with only nos for spool up and the next was an 11.5 @113 on a full pass with the small 75 shot

_________________
Nick
86 d150 turbo /6.
64 valiant 4 door

Rent an o-ring tool from Isky and do an in-car fix and it will be back on the road in a week. Use a copper head gasket too.

Tom

_________________
11.02 @ 120.56
http://www.youtube.com/watch?v=EAxRmoDgsdY
Chassis dyno
http://www.youtube.com/watch?v=wd6hFGzLJMc

would you use copper over a mls gasket?

_________________
Nick
86 d150 turbo /6.
64 valiant 4 door

Yes, but only because you can't get an MLS gasket for a slant.

_________________
Joshua

heres a good picture I found this on yellow bullet .com

_________________
Nick
86 d150 turbo /6.
64 valiant 4 door

Nice work - I would liken to see some engine pics.. Good luck working out the head gasket!


Greg

_________________
http://www.youtube.com/hyperpack