So I will be swaping a T5 into my '79 F-Body, and just need to know how to wire the Neutral safety switch to the T5,

-Mike

_________________
I am the Guardian, I hate helos, everything leaks.......

I wouldn't bother............

Ground the wire, or make sure it's not grounded.... Whatever way lets you start the engine....

_________________
Ed
64 Valiant 225 / 904 / 42:1 manual steering / 9" drum brakes

You could wire a micro switch to the clutch pedal, For a clutch safety. Bring the single wire from the start relay, to the switch and the other side of the switch to ground. The switch should be normally open.
PS: the wire from the relay at the transmission connector is the middle one.

_________________
Charrlie_S
65 Valiant 100 2dr post 170 turbo
66 Valiant Signet 170 nitrous
64 Valiant Signet
64 Valiant 4dr 170
64 Valiant 4dr 225

well I have a pedal (single ) from a 1990 Nissan 300ZX, with the neutral safety switch attached, so I take the middle wire from the trans connector and connect it to one of the wires on the neutral safety switch, and just ground out the other correct ? What about reverse lights ?

-Mike

_________________
I am the Guardian, I hate helos, everything leaks.......

Yup, that will work. Not all that familia with the 4 sp trans, but if I remember correctly, there is a switch on the rear of the trans main case. Just connect the two remaining wires from the auto trans connector (two outboard wires) to this switch.
See, it is not necessary to be a "rocket scientist".

_________________
Charrlie_S
65 Valiant 100 2dr post 170 turbo
66 Valiant Signet 170 nitrous
64 Valiant Signet
64 Valiant 4dr 170
64 Valiant 4dr 225

So true, I hate reading wiring diagrams, stuff drives me nuts lol, Thanks again Charrlie !!

-Mike

_________________
I am the Guardian, I hate helos, everything leaks.......