Anybody know what the final finish grit stones on the bores should be for the Wiseco rings?
There was no literature specifying this- 85 (600 grit) or 65 (400 grit)? on an SK10 machine.

My machinist wants to know what stone Wiseco recommends,
he said normally 65 for street and 85 for strip, I just wanted to verify if any one knows this info as it is too late to call.

Of course that means I want a 75 right LOL

P.S.
Joshua if you read this- Hone plate will be shipped to your machine shop 9:00 am tomorrow, the guy wants to let the block cool down with it on.

_________________
<img src="http://farm4.static.flickr.com/3173/2992308402_5481afb26e_t.jpg">

Don't quote me but IIRC 1st run is 280 grit followed by 400 grit. I think plateau brush was mentioned. This is what Wiseco folks told me after I bought Guzzi Mark's .45 over slugs. Someone chime in and confirm.

_________________
66 Lil' Red Piggie Valiant (Mater Crusher) - Thanks Zilla!!!!! 72 Demon (Number 1 Son's)

Depends more on what type of ring material you are using, not the brand. Stainless, moly, chrome, cast, etc....

_________________
There's no such thing as too much cam....only not enough engine!

Thyanks guys, I'll call Wiseco tomorrow and see what they recommend.

_________________
<img src="http://farm4.static.flickr.com/3173/2992308402_5481afb26e_t.jpg">