Hello, I was wondering if anyone has a part# for the ARP main studs with the provision for mounting the windage tray?



Thanks!




Greg

_________________
http://www.youtube.com/hyperpack

does anyone know about these or has anyone used them?


Do these even exist?


Do I have to special order them?


Greg

_________________
http://www.youtube.com/hyperpack

A while back I read you just use the main bolts from the V8 set big block or small block I don't remember tho.

_________________
'72 Duster /6 with turbo build up
'03 Ram 2500 4x4 w/HEMI 5sp 4:10 posi
My Twister Page

Mine came with the windage tray.........Seymour would know. Someone was building them up there. Might be in a sticky under engines. I do know if you get them too long they will block off the oil passages. The ones I use have a shoulder and a different size thread on the tray side..........hope this helps.
Seymour goes by exner geek
Regards
MaX

_________________
1966 barracuda 360
1964 signet conv. 170 turbo
Bonneville or Bust 2012

I think Maxracer is referring to the bolts that come with Mike Jeffreys windage trays. I am not sure that there are any ARP studs that mount a windage tray, Doug would know if there is.

_________________
If you didn't drive it there, it's not a street car.

Thanks............I couldn't remember. You know I never had a bit of trouble with that tray. Still using it w/ a scraper. Just torque them to the right specs, if you can still get them from Mike.
appreciated Seymour
MaX

_________________
1966 barracuda 360
1964 signet conv. 170 turbo
Bonneville or Bust 2012