Is there a preferred brand intake/Exhaust gasket? part #? Getting ready to change to Aluminum intake and headers soon.

Have you read the installation article?
http://www.slantsix.org/articles/Slant_ ... lation.htm

For me... the "best gasket" is really a good resurfacing job on the manifold set. I have set-up countless SL6 manifold assemblies and they always need to be resurfaced to get them completly flat.



Our Peterson 50 grinder is the best equipment investment I made.
Once the surfaces are clean & flat, the set can be mounted & sealed with any type of gasket.
DD

I know on the wagon I used a special gasket I got from the Cox Bros. that was very thick and had no issues with that. Thanks for the NAPA # I will check on getting that. Take care Doug.
The manifold is new IM using.

I carry the thick Aussie Gaskets PM me for pricing.
Thanks,
Frank

_________________
Scrapple: Because a mind is a terrible thing to waste.
73 Duster - Race Car
66 Dart Wagon - DD
178" FED
82 D150
All Slant powered