Slant *        6        Forum
Home Home Home
The Place to Go for Slant Six Info!
Click here to help support the Slant Six Forum!
It is currently Sun Nov 16, 2025 3:02 pm

All times are UTC-08:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
 Post subject: reverse lamps
PostPosted: Sun Jun 26, 2016 5:49 am 
Offline
3 Deuce Weber
User avatar

Joined: Sun Aug 10, 2014 2:19 am
Posts: 81
Location: Washington
Car Model:
Reverse lamps absolutely work. I crossed the brake light power to the Reverse lamps and they illuminate. Now the problem is: no reverse light power at wires in the rear... I replaced the neutral safety switch...the netrual safety switch is getting power (2 months ago when I tested it) all of the wires and plugs from the neutral safety switch are getting power all the way up to the firewall and firewall plug. I tested the backside of the firewall where the wires all plug into...all seems to get power.....The rear lights plgsug wire at kick panel (left side of drivers foot) does seem to get power at the violet and red wires....this should send power to the reverse lamps....but, on the rear, the violet wires are not getting power....! I checked all of the plugs and connections from the firewall forward towards the gas tank plugs and everything seems fine. Is there a ground problem I missed?

Is there a reverse switch in the steering column that needs replaced? bad, connection, etc?
If needed I will eventually replace the power wire from the neutral safety switch all the way back to the rear, unless there is a switch on the steering column I can't find..... pl,ease help me.

_________________
exoJjL


Top
   
 Post subject:
PostPosted: Sun Jun 26, 2016 8:17 am 
Offline
Supercharged
User avatar

Joined: Sat Feb 16, 2008 1:25 pm
Posts: 5612
Location: Downeast Maine
Car Model:
Well somewhere between seeing voltage at kick panel and back-up lamp holders the conductor is compromised. That back-up light wire is bundled with all the other conductors that feed everything from kick panel down stream to the bumper.

I suspect there is a pinched wire, and or one poorly crimped brass connector that may conduct when being manhandled during testing, and quit once unhanded.

You probably need to pull up the door sills & edge of carpet, rear bottom seat cushion and follow along driver's side of trunk exposing this bundle of wires looking for damage. You may have to unravel the vinyl wrapping to better see what's going on.

The other fix would be to disconnect the dead section of harness feeding these lights without all the tedious examination, and install a new jumper conductor wire tied to factory loom bridging the problem.

_________________
67' Dart GT Convertible; the old Chrysler Corp.
82' LeBaron Convertible; the new Chrysler Corp
07' 300 C AWD; Now by Fiat, the old new Chrysler LLC

Image


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC-08:00


Who is online

Users browsing this forum: No registered users and 10 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited