Was tunning on Bill's 1405 today trying to clear up a random miss/droppee cylinders condition. Everything looked fine until I started doing the carb spray check for vacuum leaks. Left side primary throttle shaft bore is worn out. You can literally move the shaft around 1/8" and cause the issue at will. Is there a repair kit for this or will we just sell it as is for parts?

Thanks!

_________________
Official Cookie and Mater Tormentor.

It's probably a better financial decision to get another one from a swap meet that is in good shape.
Not a lot of rebush info out there. Some Ebay stuff, but who knows there. Edelbrock and Carter throttle shafts do run a tad loose, but that sounds excessive!

I've been fortunate with the old Carter Fopar gifted me some years back. It's in awesome shape!

CJ

_________________
Part of Tyrde-Browne Racing

Thanks Ceej, but a better decision has already been made. He's ordering a Holley tomorrow.

I'll have him dump this one on E-bag for parts.

_________________
Official Cookie and Mater Tormentor.