| Slant Six Forum https://slantsix.org/forum/ |
|
| Offset Bushings Questions https://slantsix.org/forum/viewtopic.php?t=43517 |
Page 2 of 2 |
| Author: | Bruce Pine [ Wed Jun 15, 2011 9:46 pm ] |
| Post subject: | |
I have pressed control arm bushings out and new ones in just using a 6" vice. I used short galvanized pipe lengths, pipe nipples and various 1/2" drive sockets as the press/support tools. |
|
| Author: | Greg Ondayko [ Thu Jun 16, 2011 12:00 pm ] |
| Post subject: | |
Quote: I have pressed control arm bushings out and new ones in just using a 6" vice. I used short galvanized pipe lengths, pipe nipples and various 1/2" drive sockets as the press/support tools.
That works Too Bruce,Thanks for sharing. Greg |
|
| Author: | sixsignet [ Tue Jul 26, 2011 12:03 am ] |
| Post subject: | |
These posts are way better than the instructions that come with the bushings. |
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|