| Slant Six Forum https://slantsix.org/forum/ |
|
| manifold studs https://slantsix.org/forum/viewtopic.php?t=47371 |
Page 2 of 2 |
| Author: | slanted Chuck [ Sat Jan 13, 2018 4:28 pm ] |
| Post subject: | Re: manifold studs |
Hello All, I was searching the posts to find out where I can get the correct studs, brass washers, and castle bolts. I located a junkyard in Arizona (Desert Valley Auto Parts) that has several slant six motors and a ton of the listed parts. They also have the triangle washers that I have seen people requesting. The website is http://www.dvap.com They have a variety of stuff that I am going back for. I hope this will be helpful! Cheers, |
|
| Author: | SlantSixDan [ Sat Jan 13, 2018 6:07 pm ] |
| Post subject: | Re: manifold studs |
Used triangle washers are pretty much the only option because they can't be bought new. The rest of the hardware needs to be new; read this thread. |
|
| Author: | slantvaliant [ Tue Jan 16, 2018 6:21 am ] |
| Post subject: | Re: manifold studs |
Triangle washers are available new from Australia, if you want to spend the money vs picking up used parts. These seem to have been modified for aftermarket manifolds/headers. Slant Six Manifold Triangular Washers |
|
| Author: | Pierre [ Wed Jan 17, 2018 5:42 pm ] |
| Post subject: | Re: manifold studs |
Occasionally you can find NOS hardware kits that include all the special triangle and dished washers and nuts on ebay. |
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|