| Slant Six Forum https://slantsix.org/forum/ |
|
| Goin From 9 1/4" to 10" Clutch https://slantsix.org/forum/viewtopic.php?t=52746 |
Page 2 of 2 |
| Author: | DusterIdiot [ Sun Jul 21, 2013 9:51 am ] |
| Post subject: | you will also... |
Quote: Cutting them down to 1" or 3/4" should work then correct?
Yes, but the shank is too long, you'll probably need to thread another 1/2" of shank with a titanium-nitride threading set to make it right.-D.Idiot |
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|