| Slant Six Forum https://slantsix.org/forum/ |
|
| check my concept and math please https://slantsix.org/forum/viewtopic.php?t=22903 |
Page 1 of 1 |
| Author: | Bren67Cuda904 [ Thu Apr 26, 2007 4:18 pm ] |
| Post subject: | check my concept and math please |
In my car I am using the MSD 6AL with the wire cut for a 6 cylinder. My box is wired and taped into the harness and would be a real pain to get out. My builder has a new 6AL box he plans to put in this V8 truck and will let me use it. (can't cut the 6 cylinder wire) My question is about rev limiting. I want to hold my motor to no more than 6200 rpm. I believe if I install a 4600 chip that should hold me below 6133 rpm. Does this sound right? Also how do dyno's mearsure rpm. Do they just use a plug wire clamp? |
|
| Author: | emsvitil [ Thu Apr 26, 2007 5:04 pm ] |
| Post subject: | |
yes for the chip I think that's how dynos measure rpm..... |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|