| Slant Six Forum https://slantsix.org/forum/ |
|
| Torsion Bar install https://slantsix.org/forum/viewtopic.php?t=23749 |
Page 1 of 1 |
| Author: | 73NorthernDuster [ Mon Jun 25, 2007 9:13 am ] |
| Post subject: | Torsion Bar install |
I bought a new set of .920 bars for my duster ($180 cdn tax in, from the dealer). I know there is a left and right bar, but does each bar have a front and back? The numbers on the bar don't tell me much other than one side is three numbers and one end has a two numbers and a letter. Thanks in advance. Brent |
|
| Author: | slantvaliant [ Mon Jun 25, 2007 11:26 am ] |
| Post subject: | |
They don't have formal front and back ends, but if you install them with the part numbers to the rear, you and the next owner have a chance of reading the numbers through the rear socket without pulling the bars out of the lower control arms. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|