| Slant Six Forum https://slantsix.org/forum/ |
|
| Engnbldr Valves again https://slantsix.org/forum/viewtopic.php?t=26817 |
Page 1 of 1 |
| Author: | Brian [ Thu Jan 24, 2008 5:14 am ] |
| Post subject: | Engnbldr Valves again |
I know some of you guys have bought the oversized valves from Engnbldr, but has anyone actually installed these valves and have them in a running car right now? I'm looking into oversized valves for a project and have run SI valves in my racecar. What valves would you buy?? |
|
| Author: | runvs_826 [ Thu Jan 24, 2008 11:58 am ] |
| Post subject: | |
I used them in my 75' Duster, they were very nice peices and never understood/had an controversy with engrbuilder. The only problem I had were the bronze guides didn't match up and I bent a couple. I sourced the correct ones through my uncle Gary and it was together. My only arguement is with the engine I build I had wished I didn't waste them on it. I did quite a bit to it, but it still wasn't enough to need the bigger valves. However, knowing what I know know they are the best size I believe for the slant with out running into shrouding problem. Best of luck. |
|
| Author: | rock [ Thu Jan 24, 2008 1:27 pm ] |
| Post subject: | Lots of us have them in, check the search |
Hello, Lots of us have em in. Check the search for engnbldr for a relatively recent thread. I have 2 separate sets in 2 engines, for instance. rock '64d100 |
|
| Author: | LUCKY13 [ Thu Jan 24, 2008 10:24 pm ] |
| Post subject: | |
Anyone ever flowed a set of heads with these valves? If so what where the flow numbers and the port velocity's? Jess |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|