| Slant Six Forum https://slantsix.org/forum/ |
|
| Please help ID Holly carb. https://slantsix.org/forum/viewtopic.php?t=34636 |
Page 1 of 1 |
| Author: | bigslant6fan [ Wed Apr 01, 2009 12:34 pm ] |
| Post subject: | Please help ID Holly carb. |
Just bought off ebay,seller said it was 490 cfm,but I want to double check before fabricating stuff for install.# cast on top near choke horn is 6R4208,# stamped on side of choke horn is 8007 and 3442.Carb is 4bbl, vacuum sec.and elec.choke. Thank you. |
|
| Author: | Joshie225 [ Wed Apr 01, 2009 12:39 pm ] |
| Post subject: | |
If R-8007 is on the front of the choke horn that's a 390 CFM Holley 4160. http://www.holley.com/data/TechService/ ... isting.pdf |
|
| Author: | SlantSixDan [ Wed Apr 01, 2009 12:57 pm ] |
| Post subject: | |
None of those numbers is in the Holley master catalogue...are there any more? Maybe with the word "LIST" before them? |
|
| Author: | wjajr [ Wed Apr 01, 2009 4:10 pm ] |
| Post subject: | |
bigslant6fan Put a zero and a dash before 8007; = Holley part number 0-8007. Holley lists all their parts referenced to 0-8007. Summit & Jegs etc. use 4160 as a part number. Go figure! A list of places to get that carburetor running like new, and adapted to a slant six: Look here for Holley part number 0-8007 (known as a # 4160, 390 cfm carburetor) instructions. Here for technical support. Here, and Jegs, etc. for parts and rebuild kits. |
|
| Author: | bigslant6fan [ Wed Apr 01, 2009 8:03 pm ] |
| Post subject: | carb |
Thanks everyone,390cfm is what I wanted to hear. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|