Slant *        6        Forum
Home Home Home
The Place to Go for Slant Six Info!
Click here to help support the Slant Six Forum!
It is currently Fri Nov 20, 2026 6:00 am

All times are UTC-08:00




Post new topic  Reply to topic  [ 5 posts ] 
Author Message
PostPosted: Wed May 19, 2010 1:57 pm 
Offline
Turbo EFI

Joined: Sat Feb 19, 2005 9:57 am
Posts: 1818
Car Model:
do i need to replace crush sleeve???? or can i just remove nut ,yoke ????...r&r seal replace yoke,nut & torque


Top
   
 Post subject:
PostPosted: Wed May 19, 2010 2:47 pm 
Offline
Supercharged

Joined: Thu May 12, 2005 11:50 pm
Posts: 6291
Location: So California
Car Model: 64 Plymouth Valiant
You could always mark the nut, then count how many turns it takes to get it off....

Then when reinstalling, just put the nut back to it's original spot..........

_________________
Ed
64 Valiant 225 / 904 / 42:1 manual steering / 9" drum brakes

8)


Top
   
 Post subject:
PostPosted: Tue May 25, 2010 5:30 am 
Offline
Turbo EFI

Joined: Sat Feb 19, 2005 9:57 am
Posts: 1818
Car Model:
is this really that simple????


Top
   
 Post subject:
PostPosted: Tue May 25, 2010 8:39 am 
Offline
Guru
User avatar

Joined: Mon Oct 14, 2002 4:32 pm
Posts: 4880
Location: Working in Silicon Valley, USA
Car Model:
Yes... I have successfully removed and re-installed the yoke on a C.S. type rear with-out problems.
You just have to be careful to no over or under tighten the nut upon re-installation.

The main pinion bearing position is set by a solid shim on a CS set-up so gear mesh change is not the issue. The crush sleeve sits between the front and rear pinion bearings and takes-up the slack / sets the preload on those bearings.

Marking the position, nut to pinion shaft & counting the nut's turns upon removal, helps take some of the reinstall guess-work out of it.
Slowly bringing the torque back up to spec, while checking bearing clearance, (side-to-side "wiggle" and rotational friction) helps you find your way back to the correct tightness.
Get it to loose, the nut looses torque, comes-off and the grears "crash" together. (self-distruction)
Get it to tight, the pinion bearings burn-up.

In real world, it is better to have it a little tight, then a little loose.
What I usually find, is that the reinstall torque goes back to the listed factory spec. and then I put another 5 ftlbs on top of that, and it's good.
DD


Top
   
 Post subject:
PostPosted: Tue May 25, 2010 9:55 am 
Offline
Turbo EFI

Joined: Sat Feb 19, 2005 9:57 am
Posts: 1818
Car Model:
thank you doc that the info I was looking for


keep on roddin'


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 5 posts ] 

All times are UTC-08:00


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited