| Slant Six Forum https://slantsix.org/forum/ |
|
| flywheel differences slant in a 40 https://slantsix.org/forum/viewtopic.php?t=43629 |
Page 1 of 1 |
| Author: | chucksrodgarage [ Sun Feb 13, 2011 4:44 pm ] |
| Post subject: | flywheel differences slant in a 40 |
i am about ready to install the slant in the 40 plymee, and in assembling the drive line, i ran accross a problem!! it is a 66 engine with a small crank register for the flywheel. my flywheel is from a later engine. ie: register hole too large. do i have to changeout the crankshaft with a later one? which i do have here, get a new flywheel with the smaller register, or can i use it the way it is. i concerned that it may shake a little or come loose . Chuck |
|
| Author: | chucksrodgarage [ Sun Feb 13, 2011 4:47 pm ] |
| Post subject: | flywheel differences slant in a 40 |
or could i have a machine shop make a reducer ring to fit both? |
|
| Author: | hantayo13 [ Sun Feb 13, 2011 5:50 pm ] |
| Post subject: | |
you can get one made ....someone here on board might also have some keep on roddin' |
|
| Author: | Doc [ Mon Feb 14, 2011 9:27 am ] |
| Post subject: | |
Or find a small pilot flywheel... DD |
|
| Author: | chucksrodgarage [ Mon Feb 14, 2011 11:30 am ] |
| Post subject: | |
i think i located a fly wheel through the link on the forum under "wanted" thanks for the responses. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|