Slant Six Forum
https://slantsix.org/forum/

Super Six Kickdown linkage question - pickup vs pass car
https://slantsix.org/forum/viewtopic.php?t=44398
Page 1 of 1

Author:  Sixpak [ Fri Apr 08, 2011 10:10 am ]
Post subject:  Super Six Kickdown linkage question - pickup vs pass car

Anyone ever use a truck linkage rod on a pass car? I know the throttle cable bracket is the same, but it looks like the linkage rod is slightly different between a car and a truck. Seems the truck rod has a semi circle bend in it whereas the car rod has a 90' bend.

Author:  Sixpak [ Mon Apr 11, 2011 5:15 am ]
Post subject: 

Hmmm..no one has seen this before? [/img]

Author:  Jester [ Thu Apr 14, 2011 9:20 pm ]
Post subject: 

I'm fairly sure my supersix kickdown linkage originated from a pickup, and is now attached to a 72 Dart. Doesn't seem to be any issues, but maybe take a picture of each to show us what you're referring to?

Author:  Reed [ Thu Apr 14, 2011 10:12 pm ]
Post subject: 

I can verify that the long kickdown rod on a van is different than on a passenger car due to the shifter linkage arrangement on a van. The two are not interchangeable when used on a van. I can't verify a truck two barrel kickdown is different, but I would not be surprised if it was.

Author:  Jester [ Fri Apr 15, 2011 3:37 pm ]
Post subject: 

Ruh Roh! Watch my tranny grenade in a few hundred miles :shock:

Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/