I have a slant 6 and I installed the ProLine dual carb. how do i adjust kick down cable?

Post a picture of your setup, then we can see what you are working with for linkage.

Richard

_________________
Part of Tyrde-Browne Racing

http://www.flickr.com/photos/66799403@N ... otostream/

i have the lokar inc, universal kickdown kit kd-2904ht & the cable brkt & springs srk-4000 if you need more pic's just let me know. thank's

The kickdown cable should be hooked up so that it pulls the opposite of the throttle cable.
If the throttle cable is above the center of the pivot the kickdown is below pivot.

Richard

_________________
Part of Tyrde-Browne Racing

Looks like the throttle will go on the bottom and the Kickdown up with the carb linkage.
Frank

_________________
Scrapple: Because a mind is a terrible thing to waste.
73 Duster - Race Car
66 Dart Wagon - DD
178" FED
82 D150
All Slant powered

http://www.flickr.com/photos/66799403@N ... otostream/

i hooked up the accelertor cable but how do i hook up the kicked down cable so it will be pulling the opposite of the accelerator cable? photos of this setup would help me. here are more pic's

You need to attach the kick-down cable in between the pivot point of that long arm that throttle cable is attached too, and the rod that couples both carburetor’s throttle plates. So when accelerator cable pulls to fire wall, kick-down cable gets pulled in direction of radiator.

You will have to fiddle around to find the proper ark, or travel distance to have throttle pressure lever on transmission bottomed out by pull of cable at the same time carburetors are full wide open.

_________________
67' Dart GT Convertible; the old Chrysler Corp.
82' LeBaron Convertible; the new Chrysler Corp
07' 300 C AWD; Now by Fiat, the old new Chrysler LLC

do you have any pic's so i can see what your suggesting?

There are some pics of he original setup here.
When using a stay, the stay pushes the kickdown lever back against its rear positon. When using a wire, you need a bracket on the transmission so the wire can be mounted in a position where it can pull the lever back.

You will fnd complete, illustrated mounting instructions for the Bouchillon cable setup here, transmission pics near the bottom of the page.

Olaf.

_________________
Aspenized

http://www.flickr.com/photos/66799403@N ... otostream/

is this what you ment? how do i adjust it