OK
I plan to install soon/later a used Hurst ratchet shifter. I wondering if I can use self tapping bolts to mount to the floor instead of bolt/lockwasher/nut.
anyonw done this b4?
| Slant Six Forum https://slantsix.org/forum/ |
|
| will these self tapping bolts work? https://slantsix.org/forum/viewtopic.php?t=46134 |
Page 1 of 1 |
| Author: | USAJon [ Sun Aug 28, 2011 3:25 pm ] |
| Post subject: | will these self tapping bolts work? |
OK I plan to install soon/later a used Hurst ratchet shifter. I wondering if I can use self tapping bolts to mount to the floor instead of bolt/lockwasher/nut. anyonw done this b4?
|
|
| Author: | hantayo13 [ Sun Aug 28, 2011 3:41 pm ] |
| Post subject: | |
it might hold for awhile...better to drill holes and use bolts,flat& lock washers, and nuts |
|
| Author: | Rick Covalt [ Sun Aug 28, 2011 4:02 pm ] |
| Post subject: | Tap |
Jon You could run a tap up through the shifter holes and then run bolts down through. That will hold them up top for you while you go under to put washers and nuts. Rick |
|
| Author: | USAJon [ Sun Aug 28, 2011 4:13 pm ] |
| Post subject: | |
yea I just found the diagram for this unit. Hurst promatic 2 it has bolts/washers/nuts thanks all. |
|
| Author: | USAJon [ Sun Aug 28, 2011 4:13 pm ] |
| Post subject: | Re: Tap |
Quote: Jon You could run a tap up through the shifter holes and then run bolts down through. That will hold them up top for you while you go under to put washers and nuts.
man thats tits on a ritzRick thanks! |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|