has anyone ever used nylon locknuts on the uca eccentric bolts? it seems like these would keep the alignment from coming out of wack if you tap a curb a bit too hard.
| Slant Six Forum https://slantsix.org/forum/ |
|
| Nylon Locknuts on uca eccentric bolts? https://slantsix.org/forum/viewtopic.php?t=46185 |
Page 1 of 1 |
| Author: | ValiantBoyWonder [ Wed Aug 31, 2011 9:41 pm ] |
| Post subject: | Nylon Locknuts on uca eccentric bolts? |
has anyone ever used nylon locknuts on the uca eccentric bolts? it seems like these would keep the alignment from coming out of wack if you tap a curb a bit too hard.
|
|
| Author: | Dart270 [ Thu Sep 01, 2011 5:51 am ] |
| Post subject: | |
Lockwashers handle that. I've never had trouble with this. If you like extra insurance, go for it! Lou |
|
| Author: | WagonsRcool [ Mon Sep 05, 2011 7:39 pm ] |
| Post subject: | |
The only time I see alignment out of wack after "tapping a curb a bit too hard" is because something is bent. If the uca cams move then they weren't tightened to spec. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|