Hello Sages,

Any Suggestions on geatting the Rear Piston Reinstalled for the Clutch Pack?

I put a New Rubber Seal and Lubed it up - It's tough to get in there..


I do Have a Press to use; I am just afaraid of rolling the lip on the Outer Seal.



Greg

_________________
http://www.youtube.com/hyperpack

A piece of Mylar sheet cut to not quite meet at the ends when installed into the hole you are trying to put the piston/seal into, will act like a tapered ring compressor. Leave enough Mylar in heighth to be able to pull out and don't forget to lube it for the seal to slide on.

Richard

_________________
Part of Tyrde-Browne Racing

Great Tip.

Thanks Richard.


Greg

_________________
http://www.youtube.com/hyperpack

We put them in by going around the pack with a thin feeler gauge to work the lip of the seal under.

If you can't easily push the piston down with your fingers you've got the lip rolled.

_________________
Official Cookie and Mater Tormentor.

Thanks Dennis - That too is another way to go about this problem.


I was able to install it _ I just used My press and a large Ball joint socket to get it started - Problem was I couldnt get it started square just using my hands alone, then I would roll the seal.


Greg

_________________
http://www.youtube.com/hyperpack