| Slant Six Forum https://slantsix.org/forum/ |
|
| Bought a steering U joint......now what https://slantsix.org/forum/viewtopic.php?t=51122 |
Page 1 of 1 |
| Author: | Kidd [ Fri Feb 15, 2013 7:00 pm ] |
| Post subject: | Bought a steering U joint......now what |
So I just now got the box with my Sweet Mfg. steering universal joint in it.In the picture, I could see a nut on top of one end, and figured that was for the 3/4 inch steering shaft side( figured I would have to drill and run a pin in it or something) ...... Well, I open the box, and NOPE! that is a jam nut on an allen set screw on the splined side! The 3/4 inch side is just open . My question, am I supposed to weld this to the shaft? If so, why would they do that? What happens if I want to change things, like add a fire wall bearing, or change the way I have the car setup. This is a question and a vent I guess.LOL Thanks! |
|
| Author: | Fopar [ Fri Feb 15, 2013 7:14 pm ] |
| Post subject: | |
Andrew what is the part number for your U-joint? Richard |
|
| Author: | Kidd [ Fri Feb 15, 2013 9:26 pm ] |
| Post subject: | |
Part Number 910-32273 |
|
| Author: | Fopar [ Fri Feb 15, 2013 11:50 pm ] |
| Post subject: | |
Andrew you might have to post a picture as their website doesn't have a picture of it. Richard |
|
| Author: | pishta [ Sun Feb 24, 2013 9:05 pm ] |
| Post subject: | |
Yes, you weld or roll pin it. How are you going to set screw to a round shaft? |
|
| Author: | Kidd [ Wed Feb 27, 2013 7:32 am ] |
| Post subject: | |
My plan is to drill it for a roll pin, or use a grade 8 bolt. As for how round you set screw it- there is a 5/16 hole in the shaft for the roll pin, thought that it would go in there. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|