Quote:
I've always hated those clamps that you bolt the cables onto.
I've used them and actually had a wire fall out of the clamp... 
Not a good thing when it was the red wire for the main starter lead.
-D.Idiot
| Slant Six Forum https://slantsix.org/forum/ |
|
| Easy Click System https://slantsix.org/forum/viewtopic.php?t=52183 |
Page 1 of 1 |
| Author: | wjajr [ Sun May 26, 2013 5:16 am ] |
| Post subject: | Easy Click System |
Here is a simple little [url=http://www.alfadirect.com/]gizmo[/url] I discovered when looking up Dan Woods of “Chop Cut Rebuildâ€. One of the few North American distributors is [url=http://www.classicindustries.com] here [/url], search for part # EC100201. |
|
| Author: | Aggressive Ted [ Sun May 26, 2013 10:05 am ] |
| Post subject: | |
Nice! Just need to know the correct part numbers...... |
|
| Author: | 64ragtop [ Sun May 26, 2013 5:31 pm ] |
| Post subject: | |
Ted, I clicked on the "Add to Cart" button and got this: EC100201 EASY CLCK SELF TGHTNG BAT CLMP $24.99 pr Then I emptied the cart, and bailed, UNimpressed! I've always hated those clamps that you bolt the cables onto. I believe with the insulation cut back, the conductors are wide open for corrosion to start. I've seen that green creepin' crud 4-5 inches up the cable. I much prefer these . I like overkill, it beats the snot out of NO kill. Of course YMMV! BC |
|
| Author: | DusterIdiot [ Sun May 26, 2013 7:08 pm ] |
| Post subject: | X2 |
Quote: I've always hated those clamps that you bolt the cables onto.
I've used them and actually had a wire fall out of the clamp... Not a good thing when it was the red wire for the main starter lead. -D.Idiot |
|
| Author: | emsvitil [ Mon May 27, 2013 2:17 am ] |
| Post subject: | |
Put a lug on the end of the cable, then bolt the cable to the battery terminal with the bolts rather than clamp the wire with the bolts......... |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|