_________________
"Marilyn" 64 Dart GT & "Stella" 64 Valiant V100 Sedan - 63 Norton Project

Better put in a driveline loop, if the shot compromises the front u joint during a shift it ain't going to end pretty.... (hopefully the clutch will wither out before it blows also...so far all mine have...)

Looks like fun otherwise.

good advice, I blew out my rear U joint already! (I posted a pict of the new one in my last thread)



I think there is a loop laying around the garage from the last chevy project. I am still undercoating the Car and doing other stuff to her so I will look into getting one bolted on. My new Molded carpet should show up on monday so why not run more bolts thru my floor

Next is moving the battery to the trunk and getting the cold air intake on.





but next is super six'n the 4 door "Emma"

_________________
"Marilyn" 64 Dart GT & "Stella" 64 Valiant V100 Sedan - 63 Norton Project

Thanks to my Buddy in Greenwood she is also looking better.

_________________
"Marilyn" 64 Dart GT & "Stella" 64 Valiant V100 Sedan - 63 Norton Project

Cool! Keep us posted.

That's looking sharp Neil!

Your going to like the Clifford Intake. Did you get your shorties?

CJ

_________________
Part of Tyrde-Browne Racing

nahh no shorties, Just running a block off plate on a stock exhaust manifold that I had the machine shop play with. I need to get my secondarys to open a little earilyer but that is my only complaint.

Emma sure likes her super six setup with that 500cfm 2bbl that Marilyn gave her.

so the swap was a win for me

_________________
"Marilyn" 64 Dart GT & "Stella" 64 Valiant V100 Sedan - 63 Norton Project

Given what you are doing, it probably needs the short yellow spring in the secondary pod.

sounds good. I will give that a shot this weekend

Thanks!









My Four door "Emma" was playing sick.

_________________
"Marilyn" 64 Dart GT & "Stella" 64 Valiant V100 Sedan - 63 Norton Project