Slant Six Forum
https://slantsix.org/forum/

slant 6 crankshaft
https://slantsix.org/forum/viewtopic.php?t=5776		 Page 1 of 1
Author:  snowcomander6 [ Sat May 17, 2003 6:32 am ]
Post subject:  slant 6 crankshaft
Hi all, new to the board :)

Can anyone enlighten me on the slant 6 crankshaft. I need to do an engine swap in my truck (1982 Dodge 4x4 4 speed) The engine is out of a station wagon with an automatic trans. If my memory is correct the manual transmissions use a pilot bushing in the crank.

Will the crank in the engine with the auto tranny be drilled for the pilot bushing??

Thanks,
Mark K
Author:  slantzilla [ Sat May 17, 2003 12:40 pm ]
Post subject: 
If it's not, you can go to Dodge and get the roller bearing for a Dakota truck. It's about $10. :shock:

One thing to check is that the motor you want to put in is a '68 and newer. The '67 and older had a smaller register on the back of the crank. :shock:
Author:  snowcomander6 [ Sat May 17, 2003 4:29 pm ]
Post subject: 
Thanks for the info. The engine is out of a 79 Volarie wagon.

Thanks again,
Mark K
Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/