| Slant Six Forum https://slantsix.org/forum/ |
|
| Rusty Filler Nozzle https://slantsix.org/forum/viewtopic.php?t=57895 |
Page 1 of 1 |
| Author: | FrankRaso [ Mon Jun 15, 2015 12:35 pm ] |
| Post subject: | Rusty Filler Nozzle |
As I am finally getting around to replacing my rusty gas tank with a new tank, I noticed that there was rust on my filler nozzle. Most of the rust appears to be on the gas tank side of the nozzle. To avoid contaminating my new tank, I want to clean the rust off of the end of my nozzle and seal it from rusting again. I was planning to use phosphoric acid or a product like Evapo-Rust to remove the rust. I'm not sure what would be the best way of sealing it. I see from earlier posts that Por-15 and Eastwood have suitable products but I also found on other sites that there were problems with long-term adhesion of those products. It might be that the surfaces weren't properly prepared though. Has anyone cleaned and sealed their filler nozzles? Any advice for how best to proceed? |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|