| Slant Six Forum https://slantsix.org/forum/ |
|
| wiesco pistons https://slantsix.org/forum/viewtopic.php?t=58326 |
Page 1 of 1 |
| Author: | terrylittlejohn [ Fri Sep 11, 2015 4:39 am ] |
| Post subject: | wiesco pistons |
just searching and it seems the 3.5" bore piston are not available just the 3.42" and 3.44" ?? |
|
| Author: | Rick Covalt [ Fri Sep 11, 2015 6:43 am ] |
| Post subject: | |
I hope they will do more in the future as well. I bought 3.484 thinking I'd use the 3.503 for a rebuild. Rick |
|
| Author: | Dart270 [ Fri Sep 11, 2015 9:33 pm ] |
| Post subject: | |
I would try calling Wiseco or Campbellenterprises(.com) on the phone. Lou |
|
| Author: | terrylittlejohn [ Sat Sep 12, 2015 3:49 pm ] |
| Post subject: | |
I forgot Cambell Enterprises thanks Lou |
|
| Author: | Greg Ondayko [ Sat Sep 12, 2015 6:39 pm ] |
| Post subject: | |
Are you ordering 1 or 6? Part # might have changed. . I just ordered one from summit racing. Com in April. . It was at my house in 1-2 days. Greg |
|
| Author: | Greg Ondayko [ Sat Sep 12, 2015 6:53 pm ] |
| Post subject: | |
I will have to dig up the receipt and post the new part#.. it was for a single. . Not the set. Greg |
|
| Author: | terrylittlejohn [ Sat Sep 12, 2015 6:54 pm ] |
| Post subject: | |
6 going to do a low comp bottom for my drag car. |
|
| Author: | Greg Ondayko [ Sat Sep 12, 2015 7:39 pm ] |
| Post subject: | |
They seem to be avail. indvidually from the source.. http://wiseco.com/ProductDetail.aspx?ItemID=5112A104 You must be using custom rods to get low comp. I will dig up the alternative part# when I get home. Greg |
|
| Author: | Greg Ondayko [ Sun Sep 13, 2015 5:29 am ] |
| Post subject: | |
Terry, Try buying them Here: http://www.wiseco.com/ShoppingCart.aspx Or calling them too This is the part # I used in June 2015 - 5112H104 This seems to be unavailable now, Bu the old 5112A104 Part # is available. I do not see the Set available. You might have to order six individual pistons. I am sure if you call them you can get soomething sorted out. Good luck Greg. |
|
| Author: | terrylittlejohn [ Sun Sep 13, 2015 4:05 pm ] |
| Post subject: | |
no Greg, going to use stock 225 rod which will give me 7.1/1 compression. I am at 8.1/1 now. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|