Anybody have any plans of how to make a set of wood side rails/racks for a shortbed fleetside 76 D100 pickup?

Thanks!

_________________
Casually looking for a Clifford hyperpak intake for cheap.

Greetings,

I just searched youtoob for visual ideas.... Wood is not my favorite medium.
What should it look like?

https://www.youtube.com/watch?v=mubD4e6XuBs

https://www.youtube.com/watch?v=3oshHoID8Zs

https://www.youtube.com/watch?v=2XlkDrDC-3c

This is what I am going for:



These are factory side rails on a Warlock truck. Of course, my truck has a standard fleetside bed, not a stepside, but I do have two pockets on each bedrail that I hope to use as mounting points for the rack. I think I will just have to get some oak 2x4s and stainless hardware from the lumber store and get creative. What is annoying is that the pockets in the bed rails aren't 2x4. They are something like 1.5x 1.75. I will have to cut the 2x4s down so they fit in the little pockets.

_________________
Casually looking for a Clifford hyperpak intake for cheap.

2x4s are not 2x4

_________________
81 LeBaron Salon,88 5th ave,79 Aspen SE wagon,79 W150
Don't worry, nothing is going to be alright.

not exactly what was asked,, but this site specializes in LRE-Warlock stuff

http://www.dodgeconnection.com/DodgeConnectionHome.html

I have found dodge connection and am saving up money to get some of their products. However, they don't sell bed rails.

I also know a 2x4 not truly 2x4 due to shrinkage, but the stake pockets are much smaller than 2x4. Incidentally, old 2x4s actually ARE 2x4. I have come across a few while remodelling my house.

_________________
Casually looking for a Clifford hyperpak intake for cheap.