Question for Carter BBD - vacuum piston assembly:
Should the tiny wire spring be in front or behind the metering rods? Also, do I have the metering rods properly postioned in the assembly? (Refer to "front" image)
Or
| Slant Six Forum https://slantsix.org/forum/ |
|
| Do I have this installed right? https://slantsix.org/forum/viewtopic.php?t=7558 |
Page 1 of 1 |
| Author: | pantseatflyer [ Sat Nov 15, 2003 8:07 am ] |
| Post subject: | Do I have this installed right? |
Question for Carter BBD - vacuum piston assembly: Should the tiny wire spring be in front or behind the metering rods? Also, do I have the metering rods properly postioned in the assembly? (Refer to "front" image) Or
|
|
| Author: | Seis Inclinado [ Sat Nov 15, 2003 11:55 am ] |
| Post subject: | |
Metring rods are ok. The tiny spring should go in the back of the rods. See if this helps,  although the quality of your pics is a lot better he he.
|
|
| Author: | Craig [ Sat Nov 15, 2003 6:52 pm ] |
| Post subject: | |
the springs go "behind" like your second picture. they just keep the rods from flopping around in the jets and the hangers. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|