: I would guess it's only a finished manifold
: with throttle discs and shafts in place. No
: injectors, linkage, pump, lines, fuel block
: etc. That's a lot of money for something
: that can be faked out of other stuff. I'll
: bet that a clever person could take a piece
: of 1/2" aluminum plate like a manifold
: gasket, weld 1-3/4" ID 2" OD
: aluminum tubes to it at an angle, and have
: the throttle shaft holes drilled through
: end-to-end in 1 shot by a gunsmith.
: Individual throttle discs & shafts can
: be had from Holley, Carb Shop, BG, etc.
: That's most of the work if you're going for
: EFI, and parts should be less than $150. If
: you did 20 pieces, they might run $300 -
: 400. finished.

:
: 1200 bucks? whoa ...you can get a programmable
: fuelinjection to a turbo car with that....ok
: the hillborn has the looks, but it is still
: huge sum of money for that piece only...i
: think its not tha easy to find people that
: will pay it...its not the best bang for the
: buck piece?