That is exactly what I want to do. But without the roller rockers.

_________________
Charrlie_S
65 Valiant 100 2dr post 170 turbo
66 Valiant Signet 170 nitrous
64 Valiant Signet
64 Valiant 4dr 170
64 Valiant 4dr 225

If I decide to make the shims, they will look like the bottom half of those in the pic. You would still use the washer on top of the rocker shaft. Basicly make that part, cut it through the centerline and you would have two of the shims.

_________________
Excuse me, does this smell like chloroform to you?

Will, how did that trucks body get so messed up?

Will , who makes those rockers you are using?



Charlie, there you go, just what you ordered. Maybe you can talk him into making some for you. Although the height that will be needed will be effected by the valve height used in each head.



Jess

I have to figure the dimension, from the base to the centerline. Before I can do that, I need to determine the hight of the cut off stand.

_________________
Charrlie_S
65 Valiant 100 2dr post 170 turbo
66 Valiant Signet 170 nitrous
64 Valiant Signet
64 Valiant 4dr 170
64 Valiant 4dr 225

The truck got messed up when a dog ran in the road and caused a 6 car pile up.
the rockers were from Mark from the green team and are no longer avaible. Cox Bros can get you a nice set from rocker arm specialties
eather 1.5 or 1.6.