so im switching steering collumns from my dart to my valiant. is all black and nice looking if ya need to know.

got them both pulled, i unbolted column and took off shifter and they both came right out(leaving the slide in car) and i was going for the installation on the valiant! it wouldnt go in all the way, and i went to pull it back out and the slide came apart... yay, i can deal wit that. but the rest of the shaft is still in the column and wont come out.
will i be able to just hammer it in all the way? or do i need to rip it out somehow and re-insert to keep it from binding?

alright, well i just gave it the ol vice grip and hammer to get it back out, doesnt look like it goes any way, im guessin just a tight fit.
if i hammer it in, how far? will it stop?

steering column... episode 3.56
its all in!!!!!!!!!! yay...
but the wirings either a lil diff from the 72 to the 73, or it was prevously hacked
there are two fat wires aside from the two fat conectors. one red, one black. the red i got its the control side of the starter relay. but the black im confused... ground? its starts wit just the red hooked up. but ide like to know where i can hook it up